Download Installation Instructions and User Guide

Installation - First Fix
b: Without rear access once wall finished
Fit a ‘wall plate elbow’ (not supplied)
within the wall cavity and plumb in from
the shower valve. Screw the threaded
connecting tube (2) into the ‘wall-plate
elbow’ using a suitable thread sealant.
The threaded connecting tube thread
must protrude from the finished wall by
5-15mm. Once the wall has been finished,
the wall outlet (5), washer (3) and rubber
gasket (4) can be fitted to the threaded
connecting tube (using a suitable thread
sealant).
Note: If required, any decorating should
be complete now before starting the
Second Fix (below).
Take care to protect the shower valve
whilst finishing the surround.
Note: The backnut (1) is not required.
Installation - Second Fix
1. Fit concealing plate
Note: The concealing plate (7) can be
used as a template by drawing around the
plate and measuring in by 15mm to give
sufficient clearance.
Slide the concealing plate (7) onto the
shower valve control handles ensuring the
concealing plate gasket is fitted between
the plate and wall.
Concealing
plate gasket
7
17