Download Operating Instructions - FTP Directory Listing

Chapter 4 Settings — [DISPLAY OPTION] menu
[DISPLAY OPTION] menu
On the menu screen, select [DISPLAY OPTION] from the main menu, and select an item from
the sub-menu.
Refer to “Navigating through the menu” (x page 46) for the operation of the menu screen.
ff After selecting the item, press asqw to set.
[COLOR MATCHING]
Correct the color difference between projectors when using multiple projectors simultaneously.
Adjusting the color matching as desired
1) Press as to select [COLOR MATCHING].
2) Press qw to switch the item.
ff The items will switch each time you press the button.
[OFF]
Color matching adjustment is not carried out.
[3COLORS]
Adjusts the three colors [RED], [GREEN], or [BLUE].
[7COLORS]
Adjusts the seven colors [RED], [GREEN], [BLUE], [CYAN], [MAGENTA], [YELLOW], or [WHITE].
[MEASURED]
Refer to “Adjusting the color matching using a colorimeter” (x page 70) for details about this mode.
3) Select [3COLORS] or [7COLORS], and press the <ENTER> button.
ff The [3COLORS] or [7COLORS] screen is displayed.
4) Press as to select [RED], [GREEN], [BLUE], or [WHITE] ([RED], [GREEN], [BLUE], [CYAN],
[MAGENTA], [YELLOW], or [WHITE] for [7COLORS]).
5) Press the <ENTER> button.
ff The [3COLORS:RED], [3COLORS:GREEN], [3COLORS:BLUE], or [3COLORS:WHITE] screen is displayed.
For [7COLORS], the [7COLORS:RED], [7COLORS:GREEN], [7COLORS:BLUE], [7COLORS:CYAN], [7COLORS:MAGENTA],
[7COLORS:YELLOW], or [7COLORS:WHITE] screen is displayed.
6) Press as to select [RED], [GREEN], or [BLUE].
ff If [WHITE] is selected from [3COLORS], only [GAIN] can be adjusted.
7) Press qw to adjust.
ff The adjustment value changes between 0 and 2 048*1.
*1 Depends on the signal input.
Note
ff Operation when correcting the adjustment color
When the correction color same as the adjustment color is changed: The luminance of the adjustment color changes.
When correction color red is changed: Red is added to or subtracted from the adjustment color.
When correction color green is changed: Green is added to or subtracted from the adjustment color.
When correction color blue is changed: Blue is added to or subtracted from the adjustment color.
ff This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is
required to make a successful adjustment.
ff Pressing the <DEFAULT> button will restore the factory default settings for all items.
ff If [COLOR MATCHING] is set to other than [OFF], [COLOR TEMPERATURE] is fixed to [USER]. (However, [WHITE BALANCE HIGH]
cannot be adjusted.)
ff When “[PICTURE MODE]” (x page 51) is set to [DYNAMIC], [COLOR MATCHING] cannot be adjusted.
ENGLISH - 69