Download Installation and Operating Instructions

Mounting and installation
GPS Receiver
y
Procedure
Attachment point for attachment and trailer
equipment
GPS Receiver
Attachment and trailer equipment
Self-propelled machines
Distance for offset Y
x
4
Distance for offset X
Thus you can calculate the distances for machines with attachment and trailer equipment with an
ISOBUS jobcomputer:
 The jobcomputer of the farm equipment in use is connected to the terminal
 In the jobcomputer the geometry of the farm equipment is configured.
1. Measure the distance between the attachment point of the attachment and trailer equipment and
the GPS Receiver.
2. Enter the distance measured as parameter "Offset X".
3. Measure the distance between the longitudinal axis of the machine and the GPS Receiver.
4. Enter the distance measured as parameter "Offset Y".
Procedure
Thus you can calculate the distances for self-propelled machines with an ISOBUS jobcomputer:
 The jobcomputer of the farm equipment in use is connected to the terminal
 In the jobcomputer the geometry of the farm equipment is configured.
1. Enter 0 cm as parameter "Offset X".
2. Measure the distance between the longitudinal axis of the machine and the GPS Receiver.
3. Enter the distance measured as parameter "Offset Y".
For machines not fitted with a jobcomputer
Non-ISO machines are not fitted with a jobcomputer in which the so-called machine geometry can be
set up. Therefore the position of the GPS Receiver in relation to the operating point must be entered.
Procedure
Thus you can calculate the distances for all equipment without an ISOBUS jobcomputer:
1. Measuring the distance between the operating point and the GPS Receiver. e.g.: from sprayer
beam to GPS Receiver.
2. Enter the distance measured as parameter "Offset X".
3. Measure the distance between the longitudinal axis of the machine and the GPS Receiver.
4. Enter the distance measured as parameter "Offset Y".
Copyright © Müller-Elektronik GmbH & Co.KG
21