Download Operating instructions

>>>
Connecting to the cigarette
lighter
> Use the plug to insert the mains section
in the socket.
Removing power supply
> To remove the power supply, proceed
in reverse.
Note:
Remove the mains section if you are not
planning on using the Traffic Assist for a
long time.
Note:
If the cigarette lighter has just been used
and is still warm, wait until this has
cooled down in its mounting.
Power supplies using a vehicle battery are
connected up as follows using the cable supplied for the cigarette lighter.
> Hold the connector and push it, without using excessive force, to the stop in
the relevant connecting socket on the
Traffic Assist or the docking station.
> Plug the plug adapter into the cigarette
lighter.
Unit bracket
>D
The Traffic Assist can be attached directly
to the windscreen with the unit holder.
> GB
Note:
The Traffic Assist and unit bracket must
not be exposed to long periods of direct
sunlight. Temperatures inside the vehicle
of +70 C and higher may damage parts of
the bracket.
>F
>I
>E
>P
> NL
> DK
>S
>N
Note:
If the engine is switched off, using
the vehicle's power supply through the
cigarette lighter will slowly drain
the vehicle battery! Do not therefore operate the Traffic Assist for extended periods with the engine off.
> FIN
> TR
> GR
> PL
> CZ
>H
> SK
23