Download Operating Instructions PT

Using Remote control
Using Remote control
Installing and Removing batteries
2222 Install batteries and close the cover
(Insert the – side first.)
zz Remove the batteries in the reverse order of
installation.
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
JJSetting the ID number
1) While holding down the <MENU> button, press the <IMAGE> button. The number of times you press the
<IMAGE> button corresponds to the desired ID code number.
2) The number of times to press the <IMAGE> button is as follows:
Code 1= Once, Code 2= Twice, Code 3= 3 times, Code 4= 4 times
Code 5= 5 times, Code 6= 6 times
3) The ID code is changed when the <MENU> button is released.
4) The ID code is reset to [ALL] (default) by pressing the <MENU> button and <IMAGE> button at the same
time for 5 seconds or more.
Attention
zz If the <IMAGE> button is pressed 7 times or more, the ID code
cannot be changed (the operation is invalid).
zz The status of the ID code is not stored after replacing batteries.
MENU button
IMAGE button
ENGLISH - 19
Preparation
1111 Open the cover