Download Installation Manual Page 1

ON THE PALLET E
Fixings Liner Outlets & Valves (optional) Capping Steel Panels Wire strainer Gate Valve Ball Valve Bracket 20mm 40mm Anchor Bracket Tank Outlet Parabolt Parabolt OPTIONAL OUTLETS & VALVES BUILDING THE TANK 1 Minimum 300mm base edge to tank mark out the diameter RADIUS Place liner and sand in centre of tank before building LINER Top panel on the pallet = Bottom panel on the tank SAND build like BRICKS TANK Concrete Base Concrete Base Tools Required sand 17mm Pointed Spanner 300mm min Drill with 17mm and 19mm Socket concrete base 40mm bolts Note: the tank must be ROUND—
check dimensions at every level Heavy Duty Screwdriver 12mm Drill BUILDING THE TANK 2 Use podger/screwdriver to position the panels 40mm bolts
NOTE Do not fix anchor bolts until 150mm of water is in the tank INSTALLING THE LINER Outlet and gate valve optional tighten outlet with adjustable spanner use hammer to mark liner where hole will be cut bottom capping top capping liner tank panel Secure liner with capping and straining wire When installing the liner...... Seams must be vertical Folds and overlaps are minimal Liner is pushed into the corner when first filling with water Overlap on the outside is consistent Capping is applied smoothly Straining wire is installed capping capp ing
tape heavy duty PE sheet tank liner
tank liner stone free sand (50mm) Evenproducts Limited The Oxstalls Evesham Worcestershire WR11 4TU United Kingdom t: +44 1386 760 950 f: +44 1386 423 769 e: [email protected] www.evenproducts.com www.wst‐watertanks.com