Download user manual

Status messages
message


reason
The heaters are Off, the unit is shut down.
The unit is heating up to operating temperature.
The heater is at operating temperature, but Fog is not turned

on (RUN set to STBY or FOG set to 0%).
The heater is at operating temperature and the unit is under

DMX control.
The system is in Timer mode and is in a RUN period (the

number counts down to show the run time)
The system is in Timer mode and is in an OFF period (the

number counts down to show the off time)
Run out of fluid. Refill the fluid tank and operate the base

prime function (bottom right hand button on control display)
The system has detected an error with its calibration settings

and will not operate. Call Martin Service.
The system has detected an error in the temperature sensor

and will not operate. Call Martin Service.
Resetting the system after fluid out
If the system runs out of fluid simply refill the fluid container and follow the
priming instructions on page 18.
28
Status messages