Download Movifit-MC - Operating Instructions

Transcript
Startup
MOVIFIT® MC startup
I
6
0
Bus termination
The bus terminating resistors are already installed in the MOVIFIT® ABOX (with standard ABOX "MTA...-S01.-...-00" and hybrid ABOX "MTA...-S41.-...-00" only) and can be
activated using switch S1, see section "ABOX" (see page 14):
Bus termination ON = On
Bus termination OFF = Off
(factory setting)
ON
S1
ON
S1
837515659
837519755
The following table shows the operating principle of the bus termination switch:
Bus termination switch S1
Bus termination ON = On
Bus termination OFF = Off
Bus
termination
Switch
Incoming
cable
Bus
termination
Switch
ON
ON
OFF
OFF
Outgoing
cable
Incoming
cable
Outgoing
cable
837562251
837566347
TIP
When using the following connection boxes, please note:
•
Hybrid ABOX "MTA...-S51.-...-00"
•
Han-Modular® ABOX "MTA...-H11.-...-00"
In contrast to the standard ABOX, these connection boxes require a plug-in bus terminator (M12) at the last station instead of the outgoing bus connection.
Operating Instructions – MOVIFIT®-FC
95