Download SonicWALL ViewPoint User's Guide
Transcript
Configuring Reporting Settings This section describes how to configure reporting settings. These include how often the summary information is updated, the number of days that summary information is stored, and the number of days that raw data is stored. These reports are constructed from the most current available summary data. In order to create summary data, SonicWALL ViewPoint must parse the raw data files. Note: Because reports are based on the most current summary data, the report may be old. For example, if the data was summarized four hours ago, all activity that occurred since the last summary will be missing from the report. When configuring SonicWALL ViewPoint, you can select the amount of summary information to store. Summary information consumes approximately one kilobyte of information per SonicWALL appliance per day. Make sure the database is large enough to accommodate the number of days that you choose. Additionally, you can select the amount of raw data to store. The raw data is made up of information for every connection. Depending on the amount of traffic, this can quickly consume an enormous amount of space in the database. Be very careful when selecting how much raw information to store. Configuring Log Viewer Settings To configure Log Viewer settings, follow these steps: 1. Start and log into SonicWALL ViewPoint. 2. Click the Console tab. 3. Select a SonicWALL appliance. 4. Expand the Reports tree and click Log Viewer Settings. The Log Viewer Settings page appears (Figure 25). Figure 25: Log Viewer Settings Page 5. Specify how many days of raw data SonicWALL ViewPoint will store in the database from the Days To Store Raw Data list box and click Submit. To save all information, enter All. 6. To save the changes, click Submit. General Report Settings To configure SonicWALL ViewPoint settings, follow these steps: 1. Start and log into SonicWALL ViewPoint. Configuring ViewPoint 35