Download User manual Interroll AdControl

Transcript
AdControl
Maintenance and cleaning
Warning notices concerning maintenance and cleaning
CAUTION
Risk of injuries due to incorrect handling
 Maintenance work and cleaning must only be performed
by qualified and authorized persons.
 Perform maintenance work only after switching off the
power. Ensure that the system cannot be switched on
accidentally.
 Set up signs indicating that maintenance work is in
progress.
Maintenance
Inspecting the AdControl
The AdControl itself is maintenance-free. For avoidance of faults however,
regular inspection of the connections and fixings is recommended.
 As part of the regular control and maintenance work on the conveyor, ensure
that the screws of the AdControl are still tight and that the cables are still laid
properly and connected to the terminals.
Replacing the AdControl
If a AdControl is damaged, it has to be replaced.
 Install a new AdControl (see "Abandonment", page 21 and see "Installing the
AdControl in a conveyor system", page 17).
Cleaning
Dust and dirt in combination with humidity may bridge the electric circuit.
Therefore, in a dirty environment, periodic cleaning will help to avoid shortcircuits which could damage the AdControl.
CAUTION
Risk of damage to the AdControl due to incorrect
cleaning
 Do not immerse the AdControl in liquids.
 Do not use cleaning agents.
 Clean away dust and soiling if necessary.
 For more thorough cleaning, disconnect the AdControl from the power supply,
remove (see "Abandonment", page 21), and wipe over with a damp cloth.
Version 1.0 (07/2012) en
Translation of the original instructions
19