Download User's Manual

Safety Symbols
For the safe use and safe maintenance of this product, the
following symbols are used throughout this manual and on the
product. Note the meaning of each of the symbols to ensure
safe use of the product. (Not all symbols may be used.)
Notations Used in This Manual
• In this manual, the PAT-T Series regulated DC power supply
is often simply referred to as “the PAT.”
• The word “PC” used in this manual is a generic term for
personal computers and workstations.
• The following marks are used with the explanations in this
manual.
or
Indicates that a high voltage (over 1000 V) is used here.
Touching the part causes a possibly fatal electric
shock. If physical contact is required by your work,
start work only after you make sure that no voltage is
output here.
WARNING
Indicates a potentially hazardous situation which, if
ignored, could result in death or serious injury.
DANGER
Indicates an imminently hazardous situation which, if
CAUTION
ignored, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation which, if
ignored, may result in damage to the product and
other property.
Indicates a potentially hazardous situation which, if
ignored, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if
ignored, may result in damage to the product and other
property.
Indicates information that you should know.
DESCRIPTION
Explanation of terminology or operation principle.
See
Shows that the act indicated is prohibited.
Indicates reference to detailed information.
Indicates a general danger, warning, or caution.
When this symbol is marked on the product, see
the relevant sections in this manual.
SHIFT+key name (marked in blue)
Indicates a caution for hot surface of the product.
When this symbol is marked on the product, see
the relevant sections in this manual.
CFxx : x
Protective conductor terminal.
Indicates an operation in which a switch marked in blue is
pressed while holding down the SHIFT switch.
The first two characters “CF” indicates a configuration
setting, and the next two-digit number indicates the
CONFIG parameter number. The character after the colon
indicates the selected setting.
Chassis (frame) terminal.
On (supply)
Off (supply)
In position of a bi-stable push control
Out position of a bi-stable push control
PAT-T 8kW
i