Download User Manual

SORPAS® User Manual
Version 10.6
Proposed way to solve the problem: Check the entire list of density data for every
material and remove the zero values.
ERR1105: “Solution failed due to null flow stress data!”
This error occurs when at least one of the materials had zero flow stress.
Proposed way to solve the problem: Check the entire lists of flow stress data for
every material and remove the zero values.
ERR1106: “Solution failed due to null machine electric capacitance data!”
This error occurs only when applying capacitor discharge (CD) machine and the
machine capacitance was set zero.
Proposed way to solve the problem: Correct the machine capacitance data.
4.3 Run time errors
ERR2001: “There was no model selected for simulation!”
All models were unchecked or not included for simulation.
Proposed way to solve the problem: Go to <Edit Data File> and then <Process
Control> to select the necessary models for simulation.
ERR2002: “Velocity control is applicable only for deformation!”
Velocity of tool is only meaningful for deformation of materials. It is unrealistic to run
a simulation with velocity control but no deformation.
Proposed way to solve the problem: Either change to with deformation or to force
control without deformation.
ERR2003: “Cannot continue with deformation from a non-deformation calculation!”
It is not allowed to mix the history of simulations with and without deformation.
Proposed way to solve the problem: Choosing the same condition of deformation
as the previous part of the simulation.
ERR2004: “Cannot continue without deformation from a deformation calculation!”
It is not allowed to mix the history of simulations with and without deformation.
©2011 SWANTEC Software and Engineering ApS - www.swantec.com
- 113 -