1
Download ZyWALL USG User's Guide
Transcript
Chapter 11 Interfaces Table 64 Configuration > Network > Interface > VLAN > Edit (continued) LABEL DESCRIPTION OSPF Setting See Section 14.3 on page 305 for more information about OSPF. Area Select the area in which this interface belongs. Select None to disable OSPF in this interface. Priority Enter the priority (between 0 and 255) of this interface when the area is looking for a Designated Router (DR) or Backup Designated Router (BDR). The highest-priority interface identifies the DR, and the second-highest-priority interface identifies the BDR. Set the priority to zero if the interface can not be the DR or BDR. Link Cost Enter the cost (between 1 and 65,535) to route packets through this interface. Passive Interface Select this to stop forwarding OSPF routing information from the selected interface. As a result, this interface only receives routing information. Authentication Select an authentication method, or disable authentication. To exchange OSPF routing information with peer border routers, you must use the same authentication method that they use. Choices are: Same-as-Area - use the default authentication method in the area None - disable authentication Text - authenticate OSPF routing information using a plain-text password MD5 - authenticate OSPF routing information using MD5 encryption Text Authentication Key This field is available if the Authentication is Text. Type the password for text authentication. The key can consist of alphanumeric characters and the underscore, and it can be up to 16 characters long. MD5 Authentication ID This field is available if the Authentication is MD5. Type the ID for MD5 authentication. The ID can be between 1 and 255. MD5 Authentication Key This field is available if the Authentication is MD5. Type the password for MD5 authentication. The password can consist of alphanumeric characters and the underscore, and it can be up to 16 characters long. Related Setting Configure WAN TRUNK Click WAN TRUNK to go to a screen where you can set this VLAN to be part of a WAN trunk for load balancing. Configure Policy Route Click Policy Route to go to the screen where you can manually configure a policy route to associate traffic with this VLAN. OK Click OK to save your changes back to the ZyWALL. Cancel Click Cancel to exit this screen without saving. ZyWALL USG 50 User’s Guide 261
