Download Datasheet for #sbcw644 UP Recommendations
Transcript
Quantum Cascade Solutions Passage Max.-Meuron 1-3 CH-2000 Neuchâtel Case Postale 1766 Switzerland Tel: +41 32 729 95 10 Fax: +41 32 721 36 19 Datasheet for #sbcw644 UP Recommendations: Please read the starter kit user manual (at least installation chapter 5), if available, and have a look at the FAQ at http://www.alpeslasers.ch/alfaq.pdf WARNING: Operating the laser with higher current or voltage than specified in this document may cause damage and will result in loss of warranty, unless Alpes Lasers has permitted to do so! WARNING: Beware of the polarity of the laser. This laser has to be powered with negative current on the laser contact (= bonding pad, corresponding to the label ”laser” on the LLH) and the positive current on the base contact (= submount, corresponding to the label ”base” on the LLH). To use with a power-supply ILX Lightwave LDX-3232 or equivalent. Emission DN UP Figure 1: Support mounting for #sbcw644 UP (please note that the laser is connected to the UP pad drawned in blue) 1 #sbcw644 UP #sbcw644 UP 60 power (80K ) voltage (80K ) power (100K ) voltage (100K ) power (120K ) voltage (120K ) power (130K ) voltage (130K ) 8 7 50 40 Voltage [V] 6 5 30 4 20 3 10 2 0 1 0 Light [mW] avg on power meter 9 0 0.05 0.1 0.15 0.2 0.25 0.3 Current [A] 0.35 0.4 0.45 -10 0.5 Figure 2: peak voltage and average power vs peak current in continuous-wave operation (the solid squares indicate the maximum singlemode emitted power) Note: at 80K: Ith=230mA / Vth= 7.84V (4-wires measurements) Maximum operation current: 0.49A between 80 and 120K. Spectral density (normalized to 1) 120K 0.49A 120K 0.45A 120K 0.41A 100K 0.45A 100K 0.4A 100K 0.35A 100K 0.3A 80K 0.43A 80K 0.38A 80K 0.33A 80K 0.28A 80K 0.23A 1.2 80K 0.48A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5670 5680 5690 5700 Wavelength [nm] 5710 5720 Figure 3: spectra at 80K, 100K and 120K 2 #sbcw644 UP Spectral density (normalized to 1) 80K 0.43A 80K 0.38A 80K 0.33A 80K 0.28A 80K 0.48A 1.2 80K 0.23A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5670 5675 5680 5685 Wavelength [nm] 5690 5695 5684 5686 Figure 4: spectra at 80K Spectral density (normalized to 1) 80K 0.23A 1.2 80K 0.28A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5676 5678 5680 5682 Wavelength [nm] Figure 5: spectra at 80K (monomode range) 3 #sbcw644 UP Spectral density (normalized to 1) 100K 0.45A 100K 0.4A 100K 0.3A 1.2 100K 0.35A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5680 5685 5690 Wavelength [nm] 5695 5700 Figure 6: spectra at 100K Spectral density (normalized to 1) 100K 0.3A 1.2 100K 0.35A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5686 5688 5690 5692 Wavelength [nm] 5694 5696 Figure 7: spectra at 100K (monomode range) 4 #sbcw644 UP Spectral density (normalized to 1) 120K 0.49A 120K 0.41A 1.2 120K 0.45A #sbcw644 UP 1 0.8 0.6 0.4 0.2 0 -0.2 5694 5696 5698 5700 5702 5704 Wavelength [nm] 5706 5708 5710 Figure 8: spectra at 120K 5 #sbcw644 UP