Download USER MANUAL

2
3
4
5
6
7
On the left side of the Modules Online Library is a window with a list. Above the list are
two tabs and to the right is a window list containing all your modules. You may need to
wait a little bit for the list to load.
Click on the tab labeled ‘GarageCube Library’ if it is not already selected.
Within the ‘GarageCube Library’ click on the module in the list labeled
‘Slide Show (layer).’
Below the library list is an inset box that displays some text relating to the module you
have selected from the library.
Below and to the right of this description is a button labeled ‘Install >.’
Click once on the button to install the ‘Slide Show (layer)’ module.
The module you just downloaded and installed appears in the list of ‘Your Modules’.
The Slide Show (layer) module is very useful for when you may want to step through
a sequence of media in your Media Set without having to click on each thumbnail
in the Media Set window.
How to use the ‘Slide Show’ module
1
2
3
4
TIP
Your modules are stored in a folder called “Modules”
inside your “Modul8” folder where the application
is stored. While you may be able to use the module
right away. However it is not immediately stored in
this folder. To save the module(s) you have downloaded:
1
2
3
Quit Modul8 using the ‘Quit Modul8’ command
from the ‘Modul8’ menu.
A dialogue box appears with the following text:
‘Some modules have been modified or downloaded from the online library. Do you want to save
the changes?’
By clicking on ‘Save’ the module will be saved to
your module folder and Modul8 will quit.
5
Open the ‘BASICS_TUTORIAL’ project file.
If not visible access the ‘Slide Show (layer) module from the ‘Modules’ menu
under ‘Show.’
Turn on the ‘Slide Show’ module by clicking once on its play button on the upper
right corner of the module.
With your mouse cursor select the thumbnail of the first media in your ‘MEDIA SET’
window.
At the top of the ‘Slide Show’ window click once on the ‘ON/OFF’ button.
The button will change from blue to orange.
The media of your layer will now change at one second intervals. One second is
the default setting of the module.
Below and to the left of the ‘ON/OFF’ button are two buttons with arrows. By default
the button with the arrow pointing to the right is highlighted.
> Using the mouse cursor click on the left arrow button.
The media now increments in reverse. When it reaches the first media in the Media Set
the module will then jump to the last slot in the ‘media set.’
Modul8 user manual
CHAPTER 11