Download bdiGDB User Manual

Transcript
bdiGDB for CPU32/32+
User Manual
21
3.2 Configuration File
The configuration file is automatically read by the BDI2000 after every power on.
The syntax of this file is as follows:
; comment
[part name]
identifier parameter1
identifier parameter1
.....
[part name]
identifier parameter1
identifier parameter1
.....
etc.
parameter2 ..... parameterN
parameter2 ..... parameterN
; comment
parameter2 ..... parameterN
parameter2 ..... parameterN
Numeric parameters can be entered as decimal (e.g. 700) or as hexadecimal (0x80000).
3.2.1 Part [INIT]
The part [INIT] defines a list of commands which should be executed every time the target comes out
of reset. The commands are used to get the target ready for loading the program file. The SIM registers (chip select, clock, ...) are usually initialized with this command list.
WR register value
Write value to the selected register.
register
D0...D7, A0...A7, PC, SR, USP, SSP, SFC, DFC, VBR
value
the value to write into the register
Example: WR SFC 5 ;set supervisor data space
WB address value
Write a byte (8bit) to the selected memory place.
address
the memory address
value
the value to write to the target memory
Example: WB 0xFFFFFA21 0x04 ; SYPCR: watchdog disable ...
WW address value
Write a word (16bit) to the selected memory place.
address
the memory address
value
the value to write to the target memory
Example: WW 0xFFFFFA04 0x7F00 ;SYNCR: w=0, x=1 -> 16.7 MHz
WL address value
Write a long (32bit) to the selected memory place.
address
the memory address
value
the value to write to the target memory
Example: WL 0xFFFFFA48 0x00077870 ; CSBOOT 1MB, 1wait, ...
DELAY value
Delay for the selected time. A delay may be necessary to let the clock PLL
lock again after a new clock rate is selected.
value
the delay time in milliseconds (1...30000)
Example: DELAY 500 ; delay for 0.5 seconds
At the beginning of every command list, the DFC and the SFC should be set to supervisor data space.
This because all memory accesses via BDM uses the memory space selected in DFC and SFC.
© Copyright 1997-2010 by ABATRON AG Switzerland
V 1.05