Download Operating instructions DALI MULTIeco

1
2
3
...
B
Deactivating presence detection via
pushbutton
Operation (cont.)
1
2
Note: Function is locked if necessary, see “Locking and releasing pushbutton functions”.
3
When presence detection is active, the green LED on the
sensor lights up briefly each time motion is detected.
Deactivate presence detection:
min
min
Switch on if necessary.
‚Double-click.
ƒConfirmation: Luminaire switches off. Green LED on the
+ 15 s
+ 15 s
1
2
1
2
min
min
sensor lights continuously.
The presence detection is activated again the next time the
luminaire is switched on by pushbutton if presence detection is
switched on and active through selection of the corresponding
operating mode.
+ 15 s
Locking and releasing pushbutton functions
+ 15 s
2
Lock preset reference and deactivation of the presence
detection
1
2
Set the minimum brightness and press the pushbutton for
1
2
1
min
max
max
1
min
+ 15 s
+ 15 s
Locking the reset reference and manual brightness change
+ 15 s
Set the maximum brightness and press the pushbutton for
+ 15 s
2
1
2
1
another 15 seconds.
2
1
1
another 15 seconds.
‚Confirmation: Luminaire flashes.
‚Confirmation: Luminaire flashes.
> 30 s
Re-releasing all pushbutton functions
> 30 s
Press the pushbutton for 30 seconds.
max
‚Confirmation: Luminaire flashes.
2
+ 15 s
2
1
2
Adjusting the switch-off delay time
Note: When the presence detection is activated, each time a
movement is detected, the countdown of the time restarts.
> 30 s
Turn the adjusting screw to the required setting:
5 15 30
2x
1
1
< 30 s
< 30 s
2
2
3
2x
1
10 s
3
• To the left: shorter (min. 10 s)
• To the right: longer (max. 60 min)
60
min
1
time
2
Note: When presence detection is active, the load contact L’ is
only opened when the switch-off delay time has expired. This
means the control unit can be used at the same time as presence-dependent control of the room ventilation, for example.
A
max
1
2
1
1
2
< 30 s
3
2
3
1
2
3
1
2
3
A
Behaviour after a power failure
max
3
2x
B
...
B
...
After a power failure, the luminaire remains switched off until
the next time presence is detected or a pushbutton is operated.
If the “Automatic switch-off” function is switched on in the
“Brightness reduction” operating mode, the luminaire switches
on with the standby value after a power failure.
A
max
1
2
3
B
1
2
...
3
Page 3 of 4