Download Operating instructions MULTIeco

1
> 15 s
Manually switching luminaire on and off
Operation (cont.)
1
2
3
2
Via short press.
A
max
...
B
1
2
+ 15 s
1
2
Adjusting the switch-off delay time
3
Note: When the presence detection is activated, each time a
> 30
s
movement is
detected,
the countdown of the time restarts.
Turn the adjusting screw “time” (A) to the required setting:
5 15 30
60
min
1
10 s
1
2
time
• To the left: shorter (min. 10 s)
1
2
• To the right: longer (max. 60 min)
3
> 15 s
1
2
3
ON
1 2 3 4 5
> 15 s
1
ON
2
1 2 3 4 5
3
Activating/deactivating switch-off
prewarning
Shortly before expiry of the switch-off delay time, the luminaires
give a switch-off prewarning by briefly flashing.
DIP switch 4 = OFF:
Switch-off prewarning is activated.
+ 15 s
+ 15 s
DIP switch 4min
= ON:
min
Switch-off prewarning is deactivated.
A
1
1
2
2
...
B
1
2
3
+ 15
s
Deactivating
presence
detection via
s
min + 15
min
pushbutton
When presence detection is activated, the green LED on the
1
2
1
2
sensor
lights up briefly each time motion
is detected.
Deactivating presence detection:
1
2
3
Switch on if necessary.
‚Double-click.
+ 15 s is locked if necessary, see “Locking and
Note: Double-click
max + 15 s
releasingmax
double-click”.
ƒConfirmation: Luminaire switches off. Green LED on the
1
1
sensor lights continuously.
2
2
The presence detection is activated again the next time the
luminaire is switched on by pushbutton if presence detection is
switched on through selection of the corresponding operating
mode.
> 30 s
> 30 s
1
1
2
2
Locking and releasing the double-click
Lock the double-click
Switch on if necessary.
> 15 s
> 15 s
‚Press the pushbutton for 15 seconds.
ƒConfirmation: Luminaire flashes.
1
1
2
2
3
3
Double-click released
> 15 s
> 15 s
Switch off if necessary.
‚Press the pushbutton for 15 seconds.
1
1
2
2
3
3
ƒConfirmation: Luminaire flashes.
A
A
Behaviour after a power failure
B
B
1
1
2
2
3
3
1
1
2
2
3
3
...
...
After a power failure, the luminaire remains switched off. Depending on the selected operating mode, the luminaire is then
switched on according to the level of daylight, after presence
detection or manually by pushbutton.
Page 3 of 4