Download GPS AutoSteer System Installation Manual

Attaching and Adjusting Wheel Angle Sensor Linkage Rods
Attaching and Adjusting Wheel Angle Sensor Linkage
Rods
1. Install the short linkage arm on the Wheel Angle Sensor shaft.
2. Attach the Wheel Angle Sensor linkage rod to the Wheel Angle Sensor. See Figure 3-13.
Note: Leave the Wheel Angle Sensor mounting bolts loose so the sensor can be rotated after installation on the
vehicle.
Figure 3-13 Attaching the Linkage Arm to Sensor (Shown on Bench)
Wheel Angle Sensor Mounting Bolt
Washer
Allen Head Bolt
Nut
Wheel Angle Sensor Mounting Bolt
Hardware Installation Manual
79