Download USER MANUAL - Matthieu Benoit

GPPROG
usage:
where:
options:
-ds ADDR
-de ADDR
-fl ADDR
-ft B|H
-fi 1|2|4
-eq
-e
-e R,C
-a
-a R,C
-b NUM
-r NUM
-i
-h
GPPROG file [options]
file is filename containing data to be programmed.
device start address in HEX (default=MIN ADDRESS)
device end address in HEX (default=MAX ADDRESS)
file window low address (default=0)
file type is Binary|HEX (default=HEX)
file increment, 1=every byte/word, 2=every other byte/word etc.
error quiet mode, i.e. error returned only via ERRORLEVEL
displays error message on next line of screen (default)
displays error message at screen row=R, col=C
(requires ANSI.SYS)
displays current device address on next line of screen (default)
displays current device address at screen row=R, col=C (requires ANSI.SYS)
buffer size in Kbytes. Min=64, default=device size (to system max)
number of times to repeat. Each repeat is prompted at R,C. The R,C parameters of the -e
command must be specified
ignore electronic signature error and continue to program
gives this help screen
GPREAD
usage:
where:
Options:
-ds ADDR
-de ADDR
-eq
-e
-e R,C
-a
-a R,C
-h
GPREAD file [options]
file is filename for output
device start address in HEX (default=MIN ADDRESS)
device end address in HEX (default=MAX ADDRESS)
error quiet mode, i.e. error returned only via ERRORLEVEL
displays error message on next line of screen (default)
displays error message at screen row=R, col=C (requires ANSI.SYS)
displays current device address on next line of screen (default)
displays current device address at screen row=R, col=C (requires ANSI.SYS)
gives this help screen
GPVERIFY
usage:
where:
options:
-ds ADDR
-de ADDR
-fl ADDR
-ft B|H
-fi 1|2|4
-eq
-e
-e R,C
-b NUM
-r NUM
-h
GPVERIFY file [options]
file is filename to verify against
device start address in HEX (default=MIN ADDRESS)
device end address in HEX (default=MAX ADDRESS)
file window low address (default=0)
file type is Binary|HEX (default=HEX)
file increment, 1=every byte/word, 2=every other byte/word etc.
error quiet mode, i.e. error returned only via ERRORLEVEL
displays error message on next line of screen (default)
displays error message at screen row=R, col=C (requires ANSI.SYS)
buffer size in Kbytes. Min=64, default=device size (to system max)
number of times to repeat. Each repeat is prompted at R,C (the R,C parameters of the -e command
must be specified)
gives this help screen