Download Operator Manual Installation Instruction

1
2
3
4
Clamping screw
Adapter
Clamping piece
Knife holder body
RS
IO
N
5.7 Dovetail adapter
1
4
2
3
Fig. 43: Clamping (schematic diagram)
1. Move the knife holders into the standby position.
2. Loosen the clamp on the adapter and move the knife holder over
the respective cutting groove.
3. Press the knife head downwards by hand and use the plastic gauge
to adjust the knife holder to the appropriate axial gap between the
dished knife and the cutting edge of the bottom knife. (Guide value
0.8 mm)
VE
4. Tighten the knife holder clamp again.
5. Reconnect the compressed air supply.
The work is now completed.
0-
Pos : 86.3 /CAD /Hal ter Sc her enschnitt/DS- 6/D S6- S_245AC74/Linear Adapter @ 13\mod_1377595065810_4.doc x @ 218389 @ 33 @ 1
DS6S01_EN_00
51 / 70