Download ENS26 Automatic Isolation Unit Installation Manual Issue 09

Chapter 3
Mechanical Installation
3.5
Removing from the top hat rail
The ENS26 can be removed from the top hat rail.
Insert the tip of a screwdriver in the grooves (A) in the clamps at the ends
of the housing. Pull the clamps downwards (B). The ENS26 is released.
Remove the ENS26 by turning it a little (C) away from the top hat rail.
C
A
B
Attention
Never remove the ENS26 from the top hat rail using brute force. This
could damage the housing holders.
Page 16 of 20
Installation Manual ENS26
Version: A.02
Issue: 20.09.2005