Download User Manual - Badger Meter

Programming
PROGRAMMING
Programming the Badger Meter Series SDI is accomplished by installing the Data Industrial programming software on a
computer and entering data on templates of the Windows® based program.
1. Load the interface software into the computer.
2. Connect the PC to the SDI with the ASDIB-20 SDI programming kit. Plug in the RJ11 plug on the ASDIB-20 kit to the RJ11
socket on Battery Powered SDI. Connect the DB9 connector of the ASDIB-20 kit to the PC COMM port to a PC that has the
SDI software installed.
3. Open the interface software and select the appropriate COMM PORT as shown in the dialog box below.
4. Open the Parameters Screen as shown below.
5. Program the parameters using the following screens as reference.
Page 14
SEN-UM-00217-EN-09
November 2014