Download USER MANUAL - Camboard Electronics
Transcript
Using the Configuration Menus 3. Press ENT to store the current configuration as the default configuration. The following is displayed: current matrix stage is OKAY? press TAKE to confirm 4. Press TAKE. The following is displayed: current matrix stage store as DEFAULT setup • This indicates that the current setup is stored as the default setup. After a few seconds the next option on the Config Menu is displayed. 8.2.9 Config Menu—Total Matrix Reset This option lets you turn all outputs off or reset the unit to its factory default settings. To reset the matrix setup: 1. Press MENU twice. The following message is displayed: start configuration menu MENU to view setup ENT to change them 2. Press MENU until the following is displayed: TOTAL MATRIX RESET exit = ESC ENT = submenu 3. Press ENT to enter the Reset Submenu. The following is displayed: COMPLETELY MATRIX RESET 1:ALL outputs OFF2:Factory default 4. Press 1 to turn off all outputs or 2 to perform a factory reset of all options. Caution: Selecting option 2 to perform a factory default reset clears all setups, options and configuration. 5. Press TAKE and wait a few seconds. The following is displayed: Are you Absolutely sure !!! Once more TAKE to confirm 6. Press TAKE. The following is displayed: Matrix erased!!! Please, wait … The matrix and device configuration are erased. After a few seconds the next option on the Config Menu is displayed. 38 KRAMER: SIMPLE CREATIVE TECHNOLOGY