Download BL20 - User manual for BL20-PG-EN (EN)

Installation of the BL20 target files
6.2
Installation of the BL20 target files
Before configuring the BL20 station with CoDeSys and programming the BL20-PG-EN, the BL20 Target
Support Package (short: targets) have to be installed.
Target files contain all information necessary for integrating a system into the programming tool.
The Target Support Package (TSP) for the BL20-PG-EN can be downloaded from the TURCK homepage
as a zipped archive (TSP_Turck_BL20_PG_EN ×××.zip).
This archive contains the target file and other manufacturer specific files like libraries etc. which are
necessary for the operation of the gateway at CoDeSys.
The files have to be stored on your PC showing following directory structure:
Figure 6-35:
Directory structure of the target file
Note
Please observe, that the files have to be stored in this directory structure after having been
extracted from the *.zip-file.
Otherwise, problems may occur during the target installation.
6.2.1
Installation
The target installation in CoDeSys is done using the "Start → Programs→ 3S Software → CoDeSys →
V2.3 → Install Target"-command.
Figure 6-36:
Install Target
D301049 1211 BL20-PG-EN
6-3