Download User Manual - Schulz Electronic GmbH

Description of Connections
The following drawing shows all connections which are available to the user.
4 Holes for
Heatsink
(3.1 mm trough)
VCC
GND
TEC connector
screw terminals
(refer to table)
NTC and
PT100
connectors
(see table)
Switch
(shown in upper
position)
LDP-C-BOB-Connector (Pin 1 marked)
RS232 / PLB-Conn.(Pin 1 marked)
VCC
Supply voltage 12..48V, 50 V max.
GND
Supply ground
LD+
Positive laser diode output (anode). Use both connectors parallel for high
currents.
LD-
Negative laser diode output (cathode). Do not connect to ground! Use both
connectors parallel for high currents.
LDP-C BOB Conn
Mini-MOLEX Connector for Analogue/TTL-Control of the driver (see below)
RS232/PLB21-Conn
Mini-MOLEX Connector for RS232 Communication or PLB21 (see below)
3