Download User Manual

WI-MOD-9-D Radio Modem
User Manual v1.9
Response Codes
Response codes display the status of the module in response to user commands. The response
code displayed depends on the ATV setting, the ATX setting and the ATQ setting. ATV0 selects
numeric response codes. ATV1 selects verbal response codes. The ATXn command selects
extended response codes. ATQ0 disables all response messages. ATQ1 enables response
messages. The following table describes the messages. A • symbol indicates that messages is
displayed for the corresponding ATX setting.
Numeric
Code
Verbal Message
ATX setting
Comments
X0
X1
X2
X3
•
•
•
0
OK
•
1
CONNECT
•
Valid Command Entered
Connection established.
CONNECT baud is displayed for
X1,X2,X3
2
RING
•
•
•
•
Module Received an incoming
connection request
3
NO CARRIER
•
•
•
•
Connection with remote module
lost, or not initiated.
4
ERROR
•
•
•
•
Invalid Hayes command entered.
7
BUSY
•
•
X0, X1 display NO CARRIER
instead of BUSY
13
RINGING
•
X0, X1, X2 Don’t display
RINGING message
15
CONNECT 19200
•
•
•
CONNECT is displayed for X0
17
CONNECT 57600
•
•
•
CONNECT is displayed for X0
19
CONNECT 115200
•
•
•
CONNECT is displayed for X0
WI-MOD-9-D Manual v 1.9
Page 62