Download User's Manual
Transcript
3 Running GSED Execution of GSED begins interactively with a sequence of questions to be answered by the user. After specifying a preconstructed input file (see Sec. 2), the user may choose any or all of the frequency distributions listed in Tab. 1 and request calculation of any of the measures and tests listed in Tab. 2. Additional questions concern the format of the output. After all questions have been answered, GSED performs the desired calculations. Results can either be written into an output file or typed on the screen. A sample interactive sequence is given in Tabs. 6 and 7. 3.1 First run The first time an input file is read into GSED, the sequence of questions listed in Tabs. 6 and 7 appears on the screen. The meaning of these questions will be described in more detail in the following. In cases where choice of option is specified by a capital letter, small letters are also accepted (e.g., “y” instead of “Y”). ............................................................................... Input file ? : Type the name of the input file (see Sec. 2), including path specification if necessary. A maximum of 60 characters is allowed. ............................................................................... Locus configuration ? "0" : all single loci "2" : multilocus - some loci "1" : some single loci "3" : multilocus - all loci Option ? : The four options are explained as follows: Option ? : 0 Calculations will be carried out for every single locus. Option ? : 1 Calculations will be carried out for some of the single loci. As an example, the loci 2 and 4 are specified in reply to the following question: 12