Download user manual - Grote Software Systems

Transcript
Grote Software Systems
 Tab Device
Under the tab Device all basic values for the measurement are set. You can specify the offset for height
measurement (Y-axis) and position measurement (x-axis). Please pay attention to the details for the relevant
catenary measuring system. You can choose the unit systems, you can activate/deactivate the remote control and
choose a tone when receiving data. You can also choose a height correction.
4.9
Finishing
©
You can close FMcapture in two different ways.
Once with Exit in the Start Menu and the other with the Windows® close button
!
5 Troubleshooting / Hotline
©
If you receive an error message while starting FMcapture or the program does not run properly, it indicates that
the installation files are deleted accidentally or they are defective.
©
In that case run a repair from the setup of FMcapture as described in 3.2. Repair. If the error still occurs, please
contact the hotline including the following information:
information about the operating system
license number
serial number
any error code
error description
your contact details
Please send your request only via e-mail to: [email protected]
Upon receipt of your email, you will receive an answer immediately or we will call you.
30
Version 3.0.12.1
03/31/2013