Download Service Manual for Prophet

Chapter 6 – Leakage current measurement
This is a quick method to measure if any abnormal leakage current on main board which caused
high power consumption compare to GOOD main board.
(1) Requirement：
- Power Supply
- Micro-current Meter
- Current series JIG
-
CABLE
-
Battery JIG
Equipment need:
A. Power Supply (set at 4 V /1A).
B. Micro-Current Meter ( support 0.5mA ~ 1A).
B
A
2. Fixture needed
C. Cable
D. Battery with extension cable
E. Current series jig.( with black and red cable)
C
D
E
HTC confidential
© 2004, HTC Corporation. All rights reserved.
TOTAL 71
CONT.ON. 33 PAGE NO. 32