Download User's Guide - Allied Telesis
Transcript
AT-S100 Management Software User’s Guide SPEED Syntax speed 10000mfull|1000mfull|100mfull|100mhalf|100fx|10mfull| 10mhalf|auto no speed Parameters 10000mfull Specifies the interface is forced to operate at a speed of 10,000 Mbps in full duplex mode. 1000mfull Specifies the interface is forced to operate at a speed of 1,000 Mbps in full duplex mode. 100mfull Specifies the interface is forced to operate at a speed of 100 Mbps in full duplex mode. 100mhalf Specifies the interface is forced to operate at a speed of 100 Mbps in half duplex mode. 100fx Specifies the interface is forced to operate at a speed of 100FX on an uplink port (ports 25 through 28) that is connected to an SFP transceiver. This speed is available in full duplex mode only. 10mfull Specifies the interface is forced to operate at a speed of 10 Mbps in full duplex mode. 10mhalf Specifies the interface is forced to operate at a speed of 10 Mbps in half duplex mode. auto Enables auto speed and duplex configuration. Description Use the SPEED command to set the speed and duplex mode for each port on the switch. For ports ge24 through ge28, you need to manually set the port speed to 100FX when you insert an SFP into these ports. Use the no form of this command to remove the interface speed. Note To display the current port speeds, use the SHOW INTERFACE command. See “SHOW INTERFACE” on page 39. Section I: Command Modes 125