Download User's Guide - Allied Telesis

Transcript
AT-S100 Management Software User’s Guide
SPEED
Syntax
speed
10000mfull|1000mfull|100mfull|100mhalf|100fx|10mfull|
10mhalf|auto
no speed
Parameters
10000mfull
Specifies the interface is forced to operate at a speed of
10,000 Mbps in full duplex mode.
1000mfull
Specifies the interface is forced to operate at a speed of
1,000 Mbps in full duplex mode.
100mfull
Specifies the interface is forced to operate at a speed of
100 Mbps in full duplex mode.
100mhalf
Specifies the interface is forced to operate at a speed of
100 Mbps in half duplex mode.
100fx
Specifies the interface is forced to operate at a speed of
100FX on an uplink port (ports 25 through 28) that is
connected to an SFP transceiver. This speed is
available in full duplex mode only.
10mfull
Specifies the interface is forced to operate at a speed of
10 Mbps in full duplex mode.
10mhalf
Specifies the interface is forced to operate at a speed of
10 Mbps in half duplex mode.
auto
Enables auto speed and duplex configuration.
Description
Use the SPEED command to set the speed and duplex mode for each port
on the switch. For ports ge24 through ge28, you need to manually set the
port speed to 100FX when you insert an SFP into these ports.
Use the no form of this command to remove the interface speed.
Note
To display the current port speeds, use the SHOW INTERFACE
command. See “SHOW INTERFACE” on page 39.
Section I: Command Modes
125