Download IBM Netfinity ServeRAID User's Guide - ps

Transcript
About This Section
This section provides the information needed to configure an IBM ServeRAID
controller. This section also contains instructions for installing and using the
ServeRAID utility programs.
How This Section Is Organized
Chapter 1, “Getting Started,” contains an installation overview and general
information about RAID technology.
Chapter 2, “Using the Configuration Programs,” explains how to use the IBM
ServeRAID Configuration Program and the IBM ServeRAID Mini-Configuration
Program. You can refer to the information in this chapter when configuring one or
more devices attached to a ServeRAID adapter or controller.
Chapter 3, “Installing Device Drivers and Utility Programs,” contains the instructions
needed to install the ServeRAID device drivers and programs provided on the CDs
that came with your server.
Chapter 4, “Starting and Using the Utility Programs,” contains instructions for
starting and using the ServeRAID Administration and Monitoring, IPSSEND, and
IPSMON programs. You can use these operating-system specific programs to
maintain and monitor your ServeRAID subsystem.
Chapter 5, “Solving ServeRAID Problems,” describes the ServeRAID POST error
codes and startup messages. This chapter also includes some basic information
about rebuilding a defunct drive.
Notices Used in This Section
This section contains notices to highlight information as follows:
Ÿ Notes:
These notices provide important tips, guidance, or advice.
Ÿ Attention:
These notices indicate possible damage to programs, devices, or data. An
attention notice is placed just before the instruction or situation in which
damage could occur.
 Copyright IBM Corp. 1996, 1998
v