Download RC1000-PP Software User Guide

Example Programs
3.2 Checking the RC1000-PP Hardware
After installation of your RC1000-PP hardware following the
instructions in the RC1000-PP Hardware Reference Manual and
installation of the support software as described in the previous
chapter, it is recommended that you run a simple test program
provided to ensure that your hardware is functioning correctly.
The test program simply configures the FPGA and flashes the LEDs
on the board. To run the test, open a DOS prompt, change to the
utils subdirectory and type the following:
loadfpga –i CardID –c 20000000 flash##.bit
Here, you should replace CardID with the ID of the board. The IDs
of the cards in the system can be determined by typing the
following:
list
This should result in the following (or similar) output:
Number of cards in system : 1
Card ID : 2
Serial Number : 0x00000003
You should also replace the ## in the bit filename with a number
relating to the FPGA fitted to your board. Currently supplied files
are:
PCB revision
1.0
2.0
2.0
2.0
2.0
2.0
2.0
2.0
2.0
4.0
4.0
4.0
4.0
4.0
FPGA fitted
4085XL
4085XL
40150XV
40200XV
40250XV
Virtex V400
Virtex V600
Virtex V800
Virtex V1000
Virtex V1000E
Virtex V1600E
Virtex V2000E
Virtex V405E
Virtex V812E
Filename
flash85-1.bit
flash85.bit
flash150.bit
flash200.bit
flash250.bit
flashv400.bit
flashv600.bit
flashv800.bit
flashv1000.bit
flashv1000e.bit
flashv1600e.bit
flashv2000e.bit
flashv405e.bit
flashv812e.bit
The PCB revision is printed on the RC1000-PP card.
3-3