Download ThinkPad Port Replicator with Advanced EtherJet Feature User's

Part Number: 27L8358
ThinkPad Port Replicator with Advanced EtherJet Feature
User's Guide Supplement
This leaflet supplements information contained in the ThinkPad Port Replicator with Advanced EtherJet Feature User's Guide. Read the
following instructions before you begin installing your port replicator.
If your computer is the ThinkPad 560Z, attach the diskette drive to it before you begin the installation. During the installation of the port
replicator, your computer screen size is reset to 640×480.
In your User's Guide, under the heading “Cold Docking Your
Computer to the Port Replicator,” replace step 7 on page 1-6 with the
following:
1
2
The instructions could ask you to restart your computer. The
devices that Windows could detect are:
PCI Bridge (for example, PCI standard PCI to PCI Bridge)
Use the power switch to power on your computer.
When Windows detects a new device, it will notify you by
displaying some hardware wizard dialogs.
–
Follow the instructions in the dialog screen box.
–
No diskette is required.
PC Card Controller (for example, PCI-1250 CardBus
Controller)
Windows might detect “PCI-1250 CardBus Controller”
twice.
Copyright IBM Corp. 1998
1
–
No diskette is required.
Ethernet Controller (for example, Intel 8255x-based PCI
Ethernet Adapter (10/100))
–
When Windows notifies you that it detected the
Ethernet Controller, follow the instructions in the
User's Guide on page 1-9 to install this device driver
and restart the computer.
Installation of the device driver is now complete, and a Dock profile
has been created, as shown in step 8 on page 1-7 in the User's Guide.
When the computer is restarted, it might prompt you to insert the
“Display Driver Disk.” No disk is required; press OK. Then click on
Skip File several times to bypass. Press OK to restart your computer.
Open Windows Display Properties to reset your screen to a desired
color mode and a desired resolution.
The following corrects information on specified pages in the User's
Guide.
2
Page 1-8, Warm Docking and Undocking
To warm dock your computer on the port replicator:
1. Enter your computer into suspend mode; then wait until the
beep sounds and the suspend indicator is lit.
2. Close the LCD.
3. Place the computer on the port replicator.
4. Open the LCD.
To warm undock your computer from the port replicator:
1.
2.
3.
4.
Press the eject request button.
After the docking indicator turns off, close the LCD.
Press the release button to remove the computer.
Open the LCD.
Note: The computer takes a few minutes to reinitialize.
Page 1-17, Notes for Using the Port Replicator with Advanced
EtherJet Feature
Page 1-7, Cold Undocking
The README file is on the Advanced EtherJet Feature Flash
Utility Diskette.
Step 3 - There is no key on the port replicator; you must press
the release button to eject the computer.
The Flash default for the EtherJet card is DHCP.