Download Kontron User's Guide
Transcript
KTD-N0904-E Page 30 IO-Area Connectors 7.11 “Always On” (Always On) The “Always On” can be used to implement hardware controlled Always ON by jumper. When “Always On” is selected, then the board will power up automatically when power is connected. It doesn’t matter if “Always On” is not selected in BIOS. The board can still be shut down by PWRBTN_IN# (power button in) activation (via Front Panel connector). Always On pin1-2 pin2-3 X X - Description Always On selection Default position No function. Note: may load default BIOS settings after several minutes 7.12 SPI Connector (SPI) The SPI (Serial Peripheral Interface) Bus connector provides synchronous full duplex in a 9 pin header. Header Signal SPI_CLK 3.3V Pin 1 2 3 4 5 6 7 8 9 Signal GND SPI_MISO SPI_MOSI SPI_CS# SPI_CLK NC 3.3V ADDIN ISOLATE# Description Ground SPI master input, Slave Output SPI master output, Slave Input SPI slave select, active low SPI clock Not connected 3.3V Power Disable onboard SPI flash Disable the SPI interface Type PWR IO-3.3 IO-3.3 O-3.3 O-3.3 NC PWR I-3.3 I-3.3 Description Serial Clock 3.3V Standby Voltage power line. Normally output power, but when Motherboard is turned off then the on-board SPI Flash can be 3.3V power sourced via this pin. SPI_CS# CS# Chip Select, active low. ADDIN ADDIN input signal must be NC. SPI_MOSI Master Output, Slave Input. ISOLATE# The ISOLATE# input, active low, is normally NC, but must be connected to GND when programming the SPI flash. Power Supply to the Motherboard must be turned off when loading SPI flash. The pull up resistor is connected via diode to 5VSB. SPI_MISO Master Input, Slave Output SPI Data I/O: A bidirectional signal used to support Dual IO Fast Read, Quad IO Fast Read SPI_IO2_#WP and Quad Output Fast Read modes. The signal is not used in Dual Output Fast Read mode. SPI Data I/O: A bidirectional signal used to support Dual IO Fast Read, Quad IO Fast Read SPI_IO3_#HOLD and Quad Output Fast Read modes. The signal is not used in Dual Output Fast Read mode. pITX-E38 Users Guide