Download eLLiPTiCAL USeR'S GUiDe

INTRODUCTION
ASSEM B LY ST EP 7
IMPORTANT
PRECAUTIONS
LOWER HANDLEBAR
LOWER LINK ARM
SPACER RINGS
ASSEMBLY
SPACER
LOWER HANDLEBAR
ELLIPTICAL
OPERATION
BEFORE
YOU BEGIN
PRE-ATTACHED NUT, FLAT WASHER AND BOLT
CONDITIONING
GUIDELINES
PRE-ATTACHED SPACER RINGS AND SPACER
NOTE: There is no hardware bag for this step
B Slide PRE-ATTACHED SPACER into LOWER LINK ARM.
C Place 2 PRE-ATTACHED SPACER RINGS on both sides of
PRE-ATTACHED SPACER. While holding PRE-ATTACHED SPACER
RINGS, slide LOWER LINK ARM into bottom end of
LOWER HANDLEBAR.
Confirm that the
LOWER HANDLEBAR
and the LOWER LINK ARM
are marked R. The left
side is marked L.
TROUBLESHOOTING
& MAINTENANCE
A Remove PRE-ATTACHED SPACER, SPACER RINGS, BOLTS, FLAT
WASHERS and NUTS from LOWER LINK ARM.
D Insert 1 PRE-ATTACHED BOLT into LOWER HANDLEBAR and secure
using 1 PRE-ATTACHED WASHER and 1 PRE-ATTACHED NUT.
E Repeat on other side.
13
LIMITED
WARRANTY
LOWER LINK ARM