Download Installation and Operating Instructions

4
Installation instructions
Installing the sensor
4.3.4
Step 4: Install the sensor tube
Install the sensor tube
Flange 140
Nut M8
Viton gasket 140
Spring washer B8
Top of tank
Washer A8.4
Viton gasket 25x8x3
Nut M8 flat
Washer A8.4, large
Spring washer B8
Hexagonal screw M8
Procedure
1. Push the prepared sensor tube through the opening at the top of the tank.
2. Screw the sensor tube into the tube socket on the tank base.
3. Push a washer A8.4 (large) and a Viton gasket 25x8x3 onto each of the 4 hexagonal screws M8.
4. Push the screws upwards through the tank cover.
5. Push a spring washer B8 onto the screws from above.
6. Secure the screws using the nuts M8 flat.
7. Push the Viton gasket 140 and the flange downwards.
8. Push a washer A8.4 and a spring washer B8 onto the screws.
9. Secure the screws using the nuts M8.
10. You have completed the installation.
16
Copyright © Müller-Elektronik GmbH & Co.KG