Download Installation and operating instructions

Mounting and installation
Inserting a Micro-SD card
4
An appropriate connector cable for each on-board computer which can be connected is available
from Müller-Elektronik. Our sales team will be glad to advise you.
You can find a list of on-board integrated display/controllers that we have tested here:
▪ Transfer target rates via LH5000 [➙ 62]
▪ Switching sections and transferring target rates via ASD [➙ 63]
For other on-board integrated display/controllers and for on-board integrated display/controllers with
other software versions, this function may not work at all or different from how it is described in these
instructions. Because the operating mode and configuration depends on the on-board integrated
display/controller. You must contact the on-board integrated display/controller manufacturer for this.
On-board computer
Null modem cable
Adapter cable*
Available as a set with Cable 3, item number:
3032254800
Port B on the terminal
*When using an Amatron3 or Amatron+ as on-board integrated display/controller, you will only need a
traditional null modem cable. (Amatron3 and Amatron+ are on-board integrated display/controller
from Amazone)
4.9
Inserting a Micro-SD card
If your terminal is not equipped with a Micro-SD card, you can insert the card manually. You can only
use Micro-SD-format cards.
Procedure
Insert an SD card as follows:
1. Switch off the terminal and disconnect all cable connections.
2.
30322537-02-EN
V3.20140812
- Unscrew the cover on the rear of the terminal.
21