Download Installation and operating instructions

Water sensor with transmitter
Install the water sensor transmitter in the position you have checked before using the remote control
for the wireless transmission range. Please consider that metallic parts could interfere with the
wireless transmission. Install the water sensor upright as shown above (picture left top) or flat
horizontally on the floor (picture right top) in the area to be controlled. Connect the 5V-DC power
adapter.
Please consider that the 2 pins of the water sensor do not have any electrical contact to the wall,
floor. The wall mounted position should allow for the distance between the floor and the 2 pins to be
approx. 1-1.5 mm (see picture below).
Rev.: en-2014-02-12
Page 21 of 39