Download Operating instructions for sieving machine type AS300
Transcript
Requirements for the assembly site Ambient temperature : 5°C to 40°C When the ambient temperature exceeds or falls below that specified, the electrical and mechanical components may be damaged, and performance data changed to an unknown extent. Humidity : Maximum relative humidity 80% at temperatures up to 31°C, linear decline down to 50% relative humidity at 40°C At a higher humidity, the electrical and mechanical components may be damaged, and performance data changed to an unknown extent. Altitude of assembly site : Max. 2000 m above sea level Assembly / transport fastening Install the AS300 only on a stable laboratory bench to avoid unpleasant transmission of vibrations. • • • SM • Undo the hex nut SM with an open-ended spanner until the sieve disk can be moved freely Undo the wing screws A (transport fastening) with hex nuts Install the appropriate sieve clamping unit Retain wing screws A with hex nuts (transport fastening) for transport at a later date. Re-using the transport fasteners • • • Screw the hex nuts fully onto the wing screws Screw the wing screw through the sieve disk into the housing Turn the hex nut downwards and tighten with an openended spanner until the sieve disk can no longer move Mechanical components can be damaged if operated with the transport fasteners or transported without transport fasteners. Electrical connection • Refer to the data plate for the voltage and frequency at which the AS300 control is to be operated. • Ensure that the values shown there correspond to those for the local power supply. • Use the supplied power cord to connect the AS300 control to the power supply. • When plugging the power cord into the power source, use an external fuse corresponding to the local regulations. Failure to observe the values on the data plate can cause damage to the electrical and mechanical components. 18.07.2006 © Retsch GmbH 9 Doc. No. D 98.021.9999