Download Veranda EF 00202 Installation Guide

Euro Style Composite Fencing
Installation Instructions
Tools Needed:
Auger
Rubber Mallet
Power drill
Saw
Wrench
Supplies:
Wood Anchor*
Concrete Anchor*
Prior to installing fencing:



*for Surface
mounting to
concrete or
wood
Prior to digging, confirm location of underground utilities with local
authorities.
Apply for permits if required by local authorities and codes.
Local zoning laws, neighborhood associations and/or historic districts may
regulate size, type, placement and ability of fencing. Ensure compliance
prior to installation.
For questions or more information please visit
www.homedepot.com
1. Planning:




Determine total area to be fenced.
Site-Built installation: Ensure the right amount of boards and components per section.
Make adjustments for odd widths at the back corners or build partial sections equally. Example: if
you have 8 feet left in a run, consider building two 4ft sections rather than a 6ft and a 2ft.
Determine the number of posts including gate post & gate location (if applicable).
2. Layout (See diagram below)
2A. Establish total area to be fenced. Insert stakes 6” inside of proposed area extending an additional 3’
laterally so as not to disturb string lines when digging post holes.
2B. Attach string line to staked area. Verify corners are square using the 3’ x 4’ x 5’ method.
2C. Fence corners are determined by where strings intersect.
2D. Mark locations for subsequent posts starting with the first location and measuring the appropriate
distance determined by install method.
• 72” Post center to Post center
 Mark gate location and size.
 Place proper post at each location.
Tip: When marking measurements with spray paint, mark both the ground and string (see illustration).
72”
For questions or more information please visit
www.homedepot.com
Euro Style Composite Fencing
Installation Instructions
Sloped Terrain
**If your yard is not completely flat and has sloped terrain, please refer
to the following:
Determining Slope
Before you purchase or gather materials to build a fence, take the time to determine
the slope of your yard. Stake out the end points along the perimeter of your fence.
Tie mason line in between the two points. Instruments such as a water level or a
transit help you determine if the line between the two points is level. You may need
to run mason line between more than two points if the slope is extra steep to get an
accurate reading.
Sloped Properties
There are 4 ways to deal with sloped ground when building a Euro Style fence.
•
The first option is to grade the slope. Grading a slope involves cutting, digging
and re-directing the land so that it is level. However, this process may not fit your
budget or schedule, as it is time consuming and costly.
•
The second option is to step build your fence so that it follows the slope of your
property, leaving gaps between ground and bottom of fence.*
•
The third option is to rack the fence so that if follows the slope of your property,
leaving no gaps in between the ground and bottom of the fence.
•
The fourth option is to run the tops of the fences straight, so each section is lined
up with each other, leaving gaps at the bottom.*
*maximum height of 78” from ground to post top.
For questions or more information please visit
www.homedepot.com
Stepped Fencing
Stepped fences are best-suited for properties built on very steep hills. Each of the sections are
installed parallel to the next, following the rise and run of the slope. However, this stepping
structure leaves gaps between the ground and the bottom of the fence. While aesthetically
pleasing, stepped fencing is not practical for those who need fencing to contain animals keep
critters out of their garden or landscape.
Racked Fencing
Racked fencing does not end up with gaps at the bottom, like a stepped fencing. Keep in mind
when ordering materials that trimming the components at angles will shorten the fence section,
adding on extra materials. Although racking a Euro style fence is more time-consuming to
assemble, it is easier to conform to the rise and run of your slope. This type of fencing is best for
people with steep yards, who want to contain pets or keep animals out.
Straight Top Fencing
Straight top fencing does end up with gaps at the bottom, but the tops of each fence section are
in line with each other. This style will not contain pets or keep animals out. Straight top style is
great for long perimeter runs on open land, house developments or business properties.
EURO STYLE -
Material List
Post Location Image
Jewwett-Cameron Company
1-800-955-2879
Material List
A) Post
B) Channel
C) Channel Cover
D) Outer Channel Slot
E) Inner Channel Slot
F) Post Cap
G) Bracket
H) Top Board Cap
I) Bottom Support Bar
J) Composite Board
K) Aluminum Board
M) Lattice Top
N) Acrylic Top
O) Base Plate
P) Hexigon - Self Tapping Screw
Q) Base Plate Screw
Top View
Veranda Euro Style Fencing – FAQs
1) What materials is the Euro style fence made up of? The framework is powder coated aluminum, the in-fill between
the posts can also be aluminum, acrylic, or wood-polymer composites, or combinations, depending on the style you choose.
2) Are there multiple kinds of posts to buy? For all “in-line”, “ends”, “corners”, or “t” uses, the post is the same “multilpurpose” post. 3 sides have channels for stacking “in-fill”. The sides not used are covered with “channel covers” for a clean
look. The 4th side is the “show side” and has no channel.
*There is also a heavy duty Gate Post to hang your gate from. This gate post only comes in 8’ long and is used in tandem with
our adjustable Gate Frame Kit.
3) Can I install this Euro Style in the ground like a regular privacy fence? You sure can! Use the 8’ long multi-purpose
posts with 2 feet in the ground for the 6 ft. tall fence or the 6 ft. long post for the 4 ft. tall fence. Follow the simple install
instructions found at www.homedepot.com . Euro style fencing can also be surface mounted on a Patio or low level deck.
4) What are my color choices? While the aluminum is all “flat black”, the composite board parts of Veranda Euro Style
Fencing come in 3 “multi-chromatic” color families. They are BLACK ROSE’, OXFORD GREY, and KING CEDAR. All three are
randomly streaked with black so the contrast with the black framework is stunning.
5) When they say the boards are “T & G”, what do they mean?” T & G” means “tongue in groove”. It is an old
lumberman’s term that has its roots in cabin siding, porch flooring, and other traditional wood uses. One edge of every piece
has a protruding tongue while the opposite edge has a receiving groove. This milling design results in unified strength that
square edge boards could not achieve. Please note that even the aluminum accent boards are the same “T & G” design and
work in tandem with the composite.
6) My yard slopes a little bit; how will I deal with the slope? Gradual slope is dealt with the same way you would
install the typical vinyl fence panel, you would employ the “step” method. The framework and in-fill are always “level” and the
sections are “stepped up” or down these gradual slopes. Please see our “Euro on sloped terrain” install instructions at www.
homedepot.com.
7) How much maintenance does the Euro fence require? Veranda Euro Style Fencing is a low maintenance product.
There is no painting or staining of the composite boards or aluminum components. The fence can be washed with a garden
hose to rid of dirt, dust, pollen, etc.
8) Can I install Euro Style fencing on a deck? Yes, as long as the deck is 30” or lower in height. Pre-drill lag bolt holes
through wood, and secure underneath deck with washers and nuts.
9) Will my Euro Fence fade or lose color over time? Fading is very minimal when using Veranda Euro style fencing.
Comparing to a composite deck in direct sunlight that will fade up to 25%, the composite boards will fade roughly up to 4%
over its life depending on sunlight exposure.
10)Can I use the Euro Style fencing for a driveway gate? Yes you can use two Adjustable Gate Frame Kits to make a
driveway gate. Maximum width of the driveway gate is 10ft. (Drop rod/wheel support not included in Adjustable Gate Frame
Kit)
11)Do I have to buy the exact Euro fence styles that Home Depot is offering, or can I custom design my own?
Yes, you can choose to custom design your Euro Style fence any way you will like. All components are interchangeable and can
be arranged in any order.