Transcript
3 EASY STEPS Create accent corners and straight runs by simply tapping stakes through interlocking pieces to secure. Interlocking sections make continuous lengths. 1 Unsnap steel rod stakes from back of edging and insert up through holes in bottom of edging. Lay out edging along the area where you want to install. Push stakes up through border. Be sure edging pieces are touching. Tap stakes down evenly, leaving 1" from the elbow of the stake to the ground. If ground is too hard, soften it with water. DO NOT HAMMER IN COMPLETELY. This will allow you to add more edging pieces by pivoting into position and connecting to first piece. 2 Customize your edging fit by cutting between any two segments. When cutting edging, have front of section facing you. Remove desired number of segments from the right side of edging. At this point you can move steel rod to outermost holes of adjusted segment. 3 Trim line After trimming edging, move stake to new outermost hole. Continue fencing run. As you go, fit Dackers Edging pieces together with convenient interlocking system. The pieces are completely flexible, so they are easy to use in straight sections, circles and sweeping curves. When run is complete, secure border pieces by gently hammering stakes to ground level. Hammer stakes to ground level to secure permanently. Girard, PA 16417 www.emscogroup.com
