Download Broan 744SFL Instructions / Assembly
Transcript
MODEL 744SFL Page 3 WIRING OPTION #1 – Allow s f an to operate in automatic mode or manual mode ( f or odor c ontrol) by c y c ling ON/ OFF sw itc h. MODEL 68W 2-FUNCTION CONTROL (PURCHASE SEPARATELY) LIGHT (ON/OFF) BLU RED LIGHT COM ORG FAN (AUTO/OFF) GRD BLK BLK BRN WHT HUMIDITY CONTROL 4. Hang and secure housing. Hang unit from nails. Check to make sure that there will be a 1/8” gap between bottom of housing and ceiling material. Pound nails tight. For wide joist centers: A #8 x 3/8 self-tapping screw can be used to join extended brackets together and create a rigid mount. To ensure a noise-free mount, crimp the bracket channels tightly around mounting brackets. 120 BLK VAC GRD LINE IN WHT WHT FAN GRD WHT WHT WHT SWITCH UNIT WIRING OPTION #2 – Allow s f an to operate in automatic mode or manual mode ( f or odor c ontrol) by c y c ling ON/ OFF sw itc h. Fan alw ay s on w ith light. MODEL 68W 2-FUNCTION CONTROL (PURCHASE SEPARATELY) LIGHT & FAN (ON/OFF) FLUSH RED BLU LIGHT COM ORG FAN (AUTO/OFF) GRD BLK BLK HUMIDITY CONTROL 120 BLK VAC GRD LINE WHT IN FAN WHT BRN WHT WHT GRD WHT WHT SWITCH UNIT 7. Connect wiring. 5. Attach damper/duct connector. Snap the damper/duct connector onto housing. Make sure that tabs on the connector lock in housing slots. (Top of damper/duct connector will be flush with top of housing.) Install ductwork. Unit can be wired from outside of housing as shown. Use UL approved connectors to wire per local codes. FINISHED CEILING MATERIAL VERTICAL POWER CABLE CONNECTION HORIZONTAL POWER CABLE CONNECTION 6. Choose power cable direction. Remove wiring plate. When re-attached, the wiring plate allows the power cable to enter unit horizontally or vertically. CLEARANCE HOLE HOUSING COLLAR 8. Finish ceiling. Cut an opening in finished ceiling material for housing collar.
This document in other languages
- français: Broan 744SFL
- español: Broan 744SFL