Download White Rodgers F61-2510 Installation Instructions

F61 Series
Adaptor Plate Assembly
INSTALLATION INSTRUCTIONS
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
This adaptor plate assembly is designed for mounting a
Comfort-Set 70 series thermostat to the wall or to a
junction box. The wall cover plate covers the junction box,
wall damage, or old thermostat markings. The adaptor
plate is designed to allow horizontal thermostat mounting,
regardless of junction box orientation.
Adaptor Plate
All kits may not have adaptor plate or all screws shown.
No. 6 X 5/16” Phillips
pan-head screw (2)
F61-2510
Wall Plate
6-32 X 3/4” flat-head
machine screw (4)
PRECAUTIONS
! CAUTION
NOTE
To prevent electrical shock and/or equipment damage, disconnect electrical power
at main fuse or circuit breaker until installation is complete.
This instruction sheet is not intended as a wiring guide.
Refer to the thermostat installation instructions to ensure
proper wiring.
CONTENTS
Description ........................................................ 1
Precautions ....................................................... 1
Installation ......................................................... 2
PART NO. 37-6408A
White-Rodgers is a division
of Emerson Electric Co.
www.white-rodgers.com
Printed in U.S.A.
0223
INSTALLATION
FOR 1F7X DIGITAL THERMOSTATS
6-32 X 3/4” flat-head
machine screws
Junction Box
No. 6 X 5/16” Phillips
pan-head screw (2)
F61-2510
Wall Plate
Subbase
1F7X
Thermostat
Figure 1. Mounting 1F7X digital thermostat to horizontal junction box.
Locate and drill two
clearance holes in wall
6-32 X 3/4” flat-head
machine screws
Junction Box
6-32 X 3/4” flat-head
machine screws
Adaptor Plate
No. 6 X 5/16” Phillips
pan-head screw (2)
F61-2510
Wall Plate
Subbase
1F7X
Thermostat
Figure 2. Mounting 1F7X digital thermostat to vertical junction box.
2
NOTE
When installing wall cover plate and thermostat directly to
wall, use the pointed screws supplied with the thermostat.
No. 6 X 1” pan-head screws
(supplied with thermostat)
No. 6 X 5/16” Phillips
pan-head screw (2)
Wall
F61-2510
Wall Plate
Subbase
1F7X
Thermostat
Figure 3. Mounting 1F7X digital thermostat to wall.
3
For additional product information, please visit www.white-rodgers.com
The Emerson Logo is a
trademark and a service mark
of Emerson Electric Co.