Download Sony Microphone UWP-V1 User's Manual

For details on how to insert the batteries, see
“Power Supply” on page 35.
g + (+ selection) / – (– selection/reset)
buttons
Press these buttons to set the transmission
channel, frequency, or attenuation level of
the input signal.
The “–” button resets the accumulated use
time to “00:00”.
h SET button
Press to change and enter display
parameters.
For details, see “Transmitter Settings” on page 47.
i Display section
E CH (channel) indication
Shows the transmission channel. Each time
you press the SET button in transmission
mode, the channel indication changes as
follows.
For details, see “Transmitter Settings” on page 47.
Transmission
channel
Transmission
frequency
Attenuation
level of the
input signal
Press
the
SET
button.
Accumulated
use time
The channel/frequency indications for
U30 model are shown.
The channel indication (E) for U30
model is shown.
Hand-held microphone
(UTX-H2)
A AF (audio frequency) indication
Appears whenever the input audio signal is
stronger than the reference level.
B RF (radio frequency) indication
Appears during signal transmission from
the antenna.
The rear side of
the battery
compartment
C RF (radio frequency) level
indication
Shows the RF output level setting.
For details, see “Setting the RF output power level”
on page 48.
D BATT (battery) indication
Shows the battery condition.
For details, see “Battery indication” on page 36.
Parts Identification
29