Download Sony CMT-CP500MD User's Manual
Transcript
Recording tips (continued) To change the trigger level for Level Synchro Recording Perform the following procedure to change the signal level that triggers Level Synchro Recording. 1 Press FUNCTION repeatedly to switch the function to MD. 2 Press MENU/NO on the remote repeatedly until “Setup Menu” appears. Making a space between tracks 3 seconds long — Smart Space Smart Space: Lets you make the blank spaces between tracks 3 seconds long automatically while recording. If the Smart Space function is on and there is no sound input for about 3 seconds or more (but less than 30 seconds) while recording, the MD deck replaces this silence with a blank of about 3 seconds and continues recording. No sound input for less than 30 seconds 3 Press . or > for the MD until “LS(T)” appears, then press ENTER/YES on the remote. Off 4 Press . or > for the MD to select the level, then press ENTER/YES on the remote. On You can set the level at any value between –72 dB and 0 dB, in 2 dB steps. Replaced with a blank of 3 seconds and recording continues 5 Press MENU/NO on the remote. Marking track numbers at a specific point during recording — Track Mark You can mark track numbers at any time during manual recording, regardless of the type of sound source. Press MD REC z during manual recording at the point you want to add a track mark. Auto Cut: When the Smart Space function is on, if there is no sound input for 30 seconds or more, the MD deck replaces this silence with a blank of about 3 seconds and enters recording pause. No sound input for 30 seconds or more Off The tracks following the added one are renumbered. On Replaced with a blank of 3 seconds and recording pauses 22