Download Sharp FO-4400 MSDS

S H A R P
Date Revised: Apr. 8. 2008
Date Issued :May. 28.1998
MATERIAL SAFETY DATA SHEET (2/4)
MSDS
No. B-1020
Skin Contact: Flush with gently flowing water (preferably lukewarm) and soap for 15 minutes or until particle is removed.
If irritation does occur, obtain medical advice.
Eye Contact: Do not allow victim to rub eye(s). Flush with gently flowing water (preferably lukewarm) for 15 minutes or until
particle is removed. Have victim look right and left, and, then up and down. If irritation does occur, obtain medical
attention. DO NOT attempt to manually remove anything stuck to the eye(s).
Ingestion: If irritation or discomfort occurs, obtain medical attention immediately.
Note to Physician: None
Section 5. Fire-Fighting Measures
Suitable Extinguishing Media:
CO2, water spray, foam and dry chemical
Extinguishing Media to Avoid:
Full water jet
Special Firefighting Procedures:
None
Fire and Explosion Hazards:
If dispersed in air, like most finely divided organic powders, may form an explosive mixture.
Protection of Firefighters:
Use self-contained breathing apparatus (SCBA).
Section 6. Accidental Release Measures
Personal Precautions:
None
Environmental Precautions:
None
Methods for Cleaning Up:
Wipe off with paper or cloth. DO NOT use vacuum cleaner when a large amount is
released. It, like most finely divided organic powders, may create a dust explosion.
Section 7. Handling and Storage
Handling
Technical Measures: None
Precautions: None
Safe Handling Advice: Try not to disperse the particles.
Storage
Technical Measures: None
Storage Conditions: Keep container closed. Store in a cool and dry place. Keep out of reach of children.
Incompatible Products: None
Section 8. Exposure Control/Personal Protection
Engineering Measures
Ventilation: None required with intended use.
Control Parameters(As total dust)
OSHA-PEL(USA): 15mg/m3
ACGIH-TLV(USA): 10mg/m3
DFG-MAK(GER): 4mg/m3
Worksafe-TWA(Austl.): 10mg/m3
Personal Protective Equipment
None required when used as intended in Sharp equipment. For use other than normal customer-operating procedures
(such as in bulk toner processing facilities), goggles and respirators may be required.
Hygiene Measures: Wash hands after handling.
Section 9. Physical and Chemical Properties
Appearance
Physical State: Solid
Form: Powder
Color: Black
Odor:
Faint odor
Explosion Properties:
No data available
Particle Size(µm):
5 - 15
Density(g/cm³):
1.2 (bulk density: 0.5)
Boiling Point:
Not applicable
Solubility in water:
Negligible
Melting Point(°C):
Softening Point(°C):
No data available
120 - 130 *
Oxidizing Properties:
No data available
Ignition Temperature(°C): 450 *
Flash Point:
Not applicable
Vapor Pressure:
pH:
Not applicable
Not applicable