Download Sears 233.5134559 User's Manual

I
SEARS
OWNER'S
MANUAL
Model Nos,
233.51345590
233.53245590
233.53345590
Cau_om
Read and follow
all Safety Rulesand
Operating InslTuctions
before first use of this
Product.
RANGE
HOOD
•
•
•
Safety Instructions
Operation
Care and Maintenance
•
•
•
Wiring Diagram
Warranty
Parts List
Sears, Roebuck and Co., Hoffman
Estates, IL 60179 U.S.A.
OPERATION
CONTROLS
SAFETY
INSTRUCTIONS
The fat) and light are each controlled
by a rocker switch.
Th
light switch
has two positions,
"ON" and _OFF'. The fan switch
has three positions
- "HIGH",
"LOW", and "OFF". ("OFF" is the
middle
position.)
WARNING
TO REDUCE
THE RISK OF FIRE, ELECTRICAL
SHOCK,
JURY TO PERSONS,
OBSERVE THE FOLLOWING:
OR IN-
1. Use this unit only in the manner
intended
by the manufacturer. If you have questions,
contact
tile manufacturer
at the
address
or telephone
number
listed in the warranty.
2. Before servicing
vice panel
and
being switched
or cleaning
unit,
lock service
panel
on accidentally.
3. Installation
work
qualified
person(s)
and standards.
and electrical
in accordance
switch
power
off at serto prevent
power
from
wiring
with
must be done by a
all applicable
codes
4. Sufficient
air is needed
for proper
combustion
and exhausting of gases through
the flue (chimney)
of fuel burning
equipment to prevent
backdrafting.
Follow the beating
equipment
manufacturer's
guideline
and safety standards
such as those
published
by the National
Fire Protection
Association
(NFPA),
and the American
Society
for Heating,
Refrigeration
and Air
Conditioning
Engineers
(ASHRAE),
and the local code authorities.
5. When cutting
or drilling
into wall or ceiling,
electrical
wiring
and other hidden
utilities.
6. Ducted
fans
7. Do not
vice.
use
8. To reduce
9. This
unit
must
this
always
unit
with
the risk of fire,
must
be vented
do not
damage
to tile outdoors.
any solid
state
use only
metal
speed
control
de-
duetwork.
be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Keep fan, filters and grease laden surfaces clean.
2. Always turn hood ON whet) cooking at high heat.
3. Use high range settings on range only when necessary. Heat
oil slowly on low to medium setting.
4. Don't leave range unattended
when cooking.
5. Always use cookware and utensils appropriate
for the type
and amount of food being prepared.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT
OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting
lid, cookie sheet, or
metal tray, then turn off tile burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT
2. NEVER PICK LIPA FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result.
4. Use an extinguisher
ONLY if:
A. You know you have a Class ABC extinguisher
and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department
is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Firesafety Tips" published
by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or unbalanced
impellers,
keep drywall spray, construction
dust, etc. off
power unit.
3. For best capture of cooking
impurities,
your range hood
should be mounted 18-24" above the cooking surface.
4. Please read specification
label on product for further information and requirements.
CARE AND
MAINTENANCE
CLEANING
Always disconnect
the electricity
from the range hood before
servicing. Keep your range hood clean by using a mild detergent suitable for painted surfaces. DO NOT USE ABRASIVE
CLOTH, STEEL WOOL PADS OR SCOURING POWDERS. The
fan assembly is designed to be easily removed for cleaning. See
"Fan Assembly RemovaF below.
Aluminum
filters used in vented hoods are dishwasher
safe.
Avoid extremely
caustic cleaning agents, however. They may
discolor the aluminum. Clean filters once a month.
Ventless hoods are equipped
with a special ventless filter. Do
not wash the filter - its effectiveness
will be destroyed.
The
ventless filter will last up to twelve months with normal use.
Replace the filter whenever the blue side becomes noticeably
dirty or discolored.
FILTER REPLACEMENT
Filters are removed by turn(clip in low position)
ing the filter retaining clip
to the side and lifting the
filter out. Place the filter
under the embossed retaining tabs on the back of the
fan housing. Turn the filter
retaining clip so that the
low end of the clip holds
the filter in place.
In ventless hoods, MAKE
SURE THAT THE BLUE
Filter
SIDE OF THE FILTER IS
NEXT TO THE FAN WHEN THE FILTER IS INSTALLED.
NOTE: Make sure that the arrows on the filter retaining clip
point toward the front and back of the hood.
LIGHT BULB
REPLACEMENT
The light bulb (not supplied
with hood) should be 75 Watt
maximum.
Remove the light
lens covering
the bulb by
pressing
the two extending
tabs together until they release from the retaining slots
in the hood.
TO
REMOVE
Screws
FAN ASSEMBLY
Make sure that power
is
disconnected.
Remove filter.
Remove two screws holding
motor
bracket
to range
hood. Unplug fan assembly.
Be careful not to allow fan
assembly
to drop
when
screws
are removed.
Be
careful
not to bend
or
damage the fins on the blade
- they will be put out of
balance.
Screws
WIRING
DIAGRAM
WARRANTY
FULLTHREEYEARWABRANTY
r ....
SK
MOTOR
I _
UGHT
O
LAMP
II
I
w
LI
N
I
I
W
NOTE: If any of the original wire on the hood has to be rep_lced,
It sllogld be r_pfac_d by 'Mdng having eq_k, aJerd Insutatior=and
I
temperature
rating(105°CThannc_astlc
AWM,U,L,Listed)
RANGE HOOD
wfntNa BOX
ON PARTS
If within 3 years from the date of installation, any part of this range hood
fails to function properly due to a defect in matadal or workmanship, Sears
will repair the pad or furnish and install a new pad, free of charge.
FULL 30-DAYWARRANTY
METAL PARTS
ON FINISH
ON PAINTED
OR BRIGHT
If within 30 days from the date of installation, the finish on any painted or
bright metal parts of this range hood is defective in matadal or workmanship, Sears will furnish and install a new part, free of charge,
WARRANTY
SERVICE IS AVAILABLE
BY CONTACTING
THE
NEAREST
SEARS SERVICE CENTERIDEPARTMENT
IN THE
UNITED STATES,
This warranty applies only while this product is in use in the United States.
This warranty gives you specific legal rights and you may have other
rights which vary from state to state,
Sears,
Roebuck
and Ca,
Dept
817_/A,
Hoffman
Estates,
I L 60179
PARTS LIST
KEY
NO.
1
233.53245590
233.53345590
PART NO.
2
3
97009024
97000025
97009027
97009028
98006621
99150478
4
5
3
7_0307-5
99110437
97011217
233.51345590
PART NO.
97009018
97000019
98006621
99150478
97003075
991 t 0437
97011217
99020249
99260428
99020248
99260428
9
10
98005308
9_11_0
30003030
9_1_
11
12
13
14
97007937
99420472
15
16
17
18
97006931
99420472
99150415
98005221
99100379
97005544
97010709
99O9O989
99030172
97010709
99O9O989
99030172
99030248
900_2_
21
99030171
99030247
97003078
99000171
90030247
970056_
22
99150471
0015_71
19
2O
99042582
*
**
99042302
DESCRIPTION
Canopy - 24" White
Canopy - 24" Almond
Canopy - 30" White
Canopy - 00" Almond
Outlet Box Cover
9-19 x 3/8 Phillips Truss
Sheet Metal Screw*
(2 Required)
Bulb Holder with Wires
Light Lens
Screw/Nut Kit (Includes
2 - #10-16 x .500
Screws and 2 - #1916 Sheet Metal Nuts)
Fan Blade
#6-32 Locking Nuts*
(2 Required)
Motor Mounting Bracket
Motor Assembly
(Includes Key Nos. 7,
9&9)
Ventless Filter
Aluminum Filter
Filter Retainer
#8B x 1/4 Hex Head
Sheet Metal Screw*
(2 Required)
Damper Flap
Damper Bushing
Damper Assembly
(Includes Key Nos.
15 & 16)
Nameplate - Black
Nameplate - White
2-Speed Motor Switch Black
2-Speed Motor Switch White
Ught Switch - Black
Ught Switch - White
Motor Receptacle with
Wires
#10-32 x 1/2 Green
Ground Screw*
Light Bulb, 75 Watt
(Not Included)*
Installation Instructions
Standard Hardware. May be pumhaeed locally.
Not Illustrated.
MODEL
233.51345590
17_
4'
16
19 20
21
12
13
MODELS
233.53245590
233
19 20
21
11
13
3
_
SEARS
OWNER'S
MANUAL
Model Nos.
233.51345590
233.53245590
233.53345590
RANGE
HOOD
For the repair or replacement parts you need
Call 7 am - 7 pro, 7 days a week
1-800-366-PART
(1-800-366-7278)
For in-home major brand repair service
Call 24 hours a day, 7 days a week
1-800-4-REPAIR
(1-800-473-7247)
The model number of
your range hood is found
on a label inside the
hood.
For the location of a
Sears Repair Service Center in your area
Call 24 hours a day, 7 days a week
1-800-488-1222
When requesting
service or ordering
parts, always provide the
following
information:
Product Type
Model Number
Part Number
Part Description
For information on purchasing a Sears
Maintenance Agreement or to inquire
about an existing Agreement
call 9 am - 5 pro, Monday-Saturday
1-800-827-6655
SEARS
Arr_w_'s
Sears, Roebuck and C_, Holfman
Re_ir Specialists
Estates, IL 60179 U.S.A.
99042S83A