Download Quantum DAT 24 Drive User's Guide
Transcript
Commands: Mode Sense (1Ah) Page 91 MODE SENSE Parameters The parameter list for the MODE SENSE command contains • A four-byte header, followed by • Zero or one eight-byte Block Descriptor, followed by • Zero or more variable-length pages. The following table illustrates the structure of the Mode Sense command. Byte Bits 7 6 5 4 0 . . 3 3 2 1 0 Parameter List Header 4 . . 11 Block Descriptor 12 . . . n Mode Pages The MODE SENSE response data consists of a four-byte header followed by an eight-byte block descriptor. The following table shows the header format. Byte Bits 7 6 5 4 3 2 0 Mode Sense Data Length 1 Medium Type Field WP 2 BUF BUF BUF 0 0 1 0 0 0 Block Descriptor Length 3 Parameter List Header Field Descriptions The following table defines the fields in the MODE SENSE Header. Field Name Bytes Bits Description Mode Sense Data Length 0 This field specifies the number of bytes in the following Mode Sense data that is available to be transferred If the Transfer Length is smaller than the MODE SENSE Data Length, only Transfer Length bytes of the MODE SENSE data are transferred. The Sense Data Length does not include itself. BUF 2 6-4 When this field is 1 the drive operates in buffered mode. In buffered mode, a WRITE command is terminated when the data is transferred to the internal buffer of the drive. When this field is 0 the drive is in unbuffered mode and all data is written to tape before command completion is returned. In non-buffered mode, a WRITE command is not terminated until all data has been transferred to tape. WP 2 7 If this bit is 1, the tape is write-protected. If this bit is 0, the tape is writeenabled.